D) Installing The Antenna Wire; E) Mounting The Elevator Unit - Reely PRO Bedienungsanleitung

d) Installing the antenna wire

• On delivery, the antenna wire is wrapped around the
two skids. To ensure interference-free signal
transmission, you need to unwrap the antenna wire and
fix it on the model.
• It is best to guide the antenna wire to the rear along the
right side of the model (1) wrap it around the bottom
strut of the tail extension (2) and fix it in place on the tail
with an adhesive strip (3).
Then the excess end of the wire hangs down loosely
and is tailed in flight.

e) Mounting the elevator unit

• The two halves of the elevator unit (1 and 2) are slid
through the prepared openings on the left and the right
of the tail extension (3) and stuck together in the middle.
Do not use excessive force, otherwise the elevator unit
supports may easily break off.
• If necessary, smoothen the elevator unit supports slightly
with a key file.
46
Figure 6
Figure 7