Tail Function - Reely PRO Bedienungsanleitung

Tail Function

As the helicopter is equipped with two counter-rotating rotors, there is no torque around the yaw axis (rotor shaft). The
helicopter does not need a tail rotor for stabilization.
To allow the model to turn around the yaw axis, the rotors run with slightly different speeds and the model begins to
turn (see figure 11, Pos. B). The control of the tail function is effected with the left control stick also (see figure 1, Pos.
10).
• If the stick is steered slightly towards the left, the tip of the fuselage turns towards the left.
• If you steer towards the right, the tip of the fuselage turns likewise towards the right.
Roll Function
The roll function allows you to move your model helicopter sideways to the right and to the left (see figure 11, Pos.C).
The control is effected with the right control stick (see figure 1, Pos. 4).
• If the stick is steered slightly towards the left, the model drifts sideways to the left.
• If you steer to the right, the model drifts sideways to the right.
Nod function
The nod function allows you to move your model helicopter forward and backward (see figure 11, Pos.D). The right
control stick (see ill. 1, pos. 4) is used for this as well.
• If you press the stick slightly forward, the model flies forward.
• If you pull the stick towards the back, the model flies backwards.
49