Programs Of The Design Mixer Advanced Professional; Auxiliary Functions - Gastroback Design Mixer Advanced Professional Bedienungsanleitung

Programs of the Design Mixer Advenced Professional
You select the desired program by pressing the assigned program button on the control panel
(see: ›Knowing Your Design Mixer Advanced Professional‹). The corresponding program
number is shown on the LCD screen. The processing time depends on the selected program.
The Design Mixer Advanced Professional offers 5 pre-defined programs for processing your
food and 3 auxiliary functions.
Program Duration
Button
PULSE 60 seconds
ICE CRUSH
SMOOTHIE 60 seconds
GREEN 60 seconds
SMOOTHIE
FROZEN 60 seconds
DESSERT
SOUP 6 minutes
AUTO Removes most of the ingredients off the jugs walls and cutting blades. Add
CLEAN 500 ml warm soapy water, and press the AUTO CLEAN button. For harder
to clean, sticky or thick ingredients, add ½ teaspoon of dish liquid detergent
for extra cleaning power. For best results, run the clean cycle immediately
after use.
Pauses and holds a program for up to 2 minutes. Press the pause button
Pause ( )
again to continue. Pause is also activated, if the jug is removed from base
during use. Replace the jug, and press the pause button to resume.
IMPoRTANT: If the appliance is running and you press a different program button, it will
switch to that program without stopping.
Programs for Processing food
function
For crushing ice.Has an intelligent sensor to stop the motor
when ice is done. This cycle is also ideal for processing
other foods that need sudden bursts of power.
Optimised to combine and aerate frozen and liquid ingre-
dients together. The program uses a unique technique, that
blends the denser ingredients at lower speed, then increa-
ses in speed as ingredients thicken. This will happen seve-
ral times during operation. The program also circulates the
ingredients for maximum aeration and a creamy texture.
Optimised to break down whole hard ingredients like fruits,
leafy greens and seeds, and allows them to blend together
with other soft and liquid ingredients.
To break down and combine frozen ingredients quickly. Use
the pusher for best results.
Blend and heat ingredients to make soups. This pre-set
program runs for 6 minutes. The program has a slow start
to combine ingredients before running at high speed, and
ends with a couple of stirs to release any steam bubbles that
may have formed in the soup.

Auxiliary functions

62