Fig. 22 Battery Pack - Otto Bock A200 Gebrauchsanweisung

Fig. 22 Battery pack
The applied AGM technology fulfils the latest provisions re-
garding safety and environmental tolerance through close
construction.
For increased safety and to facilitate handling, the batteries
are integrated in separate battery packs. Thanks to special
lead plates, these batteries are particular well-suited for
electric drive systems and have been designed with a high
cycle solidity.
For exchange or disposal of the batteries (batteries within
battery pack), please contact your authorized dealer. The
batteries are to be replaced as complete units (battery
packs).
A200
To remove / replace the battery packs proceed as follows:
1. Release the seat lock by simultaneously pulling the
release strap and folding the locking bar to the rear
(Fig. 6).
2. The battery packs are free. Remove the battery packs
(Fig. 23).
3. Place the new battery packs into the drive unit sustai-
ner. Take care that the red arrows on the battery packs
point in driving direction and that the plug connections
(Fig. 24) engage into the battery contacts.
4. To prevent the battery packs from falling out of the
drive unit sustainer, the locking lever must be relocated
(Fig. 10).
Operation
Ottobock 113
|