To apply the lap belt, insert the two buckle halves into each
other until they lock in place Fig. 29). The belt buckle must
snap in place audibly. Then, verify that the belt has locked
by trying to pulling it apart.
To open the lap belt, press the red release button.
The belt length can be adjusted on both sides. To set the
length, position both buckle halves in the middle of the body.
After positioning the buckle halves at a right angle in relation
to the belt, their position can be varied. Any excessive belt
length will be held in place by the plastic slides.
Fig. 29
Applying the lap belt
A200
7.5 Other Options
Curb climbing assist: The curb climbing assist is used
to clear curbs and steps that have a maximum height of
80 mm.
Puncture-proof tyres: Solid rubber tyres
contoured seats, small/large: for better sitting comfort
and more adaptation possibilities
Standard seat, junior
Armrest accessories: Special adapter for the armrests
of our Accessories Catalogue
Adapter for headrest mounting kit:
For attachment to the back tube
Additional lights
These and other optional add-on components are included
in the order form and in the accessories catalogue.
Accessories
Ottobock
121
|