Scheppach HSM3500 Originalbetriebsanleitung Seite 31

• Only work with diamond cutting wheels which are
exclusively suitable for wet cutting.
• Use diamond cutting wheels which are the correct
size.
• Keep you hands, fingers and arms away from the
rotating cutting wheel. Always maintain sufficient
clearance from the diamond cutting wheel.
• Replace faulty diamond cutting wheels immediate-
ly. Deformed or cracked cutting wheels may not be
used.
• Only use diamond cutting wheels recommended by
the manufacturer which conform to EN 13236. The
use of any type of saw blades is prohibited.
• Make sure that a suitable diamond cutting wheel for
the material to be cut is selected.
• Do not use the stone cutting machine without safety
equipment.
• Always switch off the machine and pull out the
mains plug for the correction of errors or removal
of jammed workpieces. Only remove the jammed
workpiece after doing so.
• Protect the diamond cutting wheel from impact and
jarring. Do not subject it to any lateral pressure.
• Do not stress the device to the extent that it is
brought to a stop.
• Wear suitable personal protective equipment (PPE).
- Hearing protection to avoid the risk of becoming
hearing impaired.
Attention! Noise can be harmful to the health.
If the permissible noise level of 80 dB(A) is
exceeded, hearing protection must be worn.
- Respiratory protection to avoid the risk of inhal-
ing harmful dust.
- Eye protection to avoid the risk of injuring the
eyes.
- Gloves are recommended when handling raw
materials and shoes with non-slip soles when
working outdoors.
• Diamond cutting wheels must always be carried in a
container whenever practical.
• This machine may only be operated by persons who
are familiar with stone cutting machines.
• Errors in the machine, including all covers and pro-
tective devices must be reported to the person re-
sponsible for safety as soon as they are discovered.
• Do not leave the device running unattended.
ADDITIONAL SAFETY INSTRUCTIONS
Read all instructions before operating this product!
Workstation
To avoid the risk of injury, machine damage, fire and
shock, ensure that your workstation
• is protected from damp, moisture and rain,
• is free of flammable gases and liquids,
• is childproof – use padlocks and main switches
when the machine is not in operation;
• is clean and empty,
• is well-ventilated and well-lit.
The operating person
Common sense and caution are factors that cannot be
fitted into a machine. These factors are the responsibil-
ity of the operator. Please remember:
• Avoid physical contact with earthed surfaces, such
as pipes or radiators.
• Stay alert. Do not work on the machine if you are
tired.
• Do not operate the product under the influence of
alcohol or drugs.
• Read the warning notices to determine whether your
judgement or reflexes could be impaired.
• Do not wear loose clothing or jewellery that could
get caught in rotating parts.
• Non-slip footwear is recommended.
• Protect long hair with suitable means.
• Wear eye and ear protection. Always wear:
- ANSI-approved dust masks.
- Hearing protection.
• Keep your balance at all times.
• Do not stand over the machine while it is running.
Residual risks
The machine has been built according to the state-
of-the-art and the recognised technical safety re-
quirements. However, individual residual risks can
arise during operation.
• Danger of injury for fingers and hands due to the
running cutting tool with improper guiding of the
workpiece.
• Risk to health due to dust. It is essential that personal
protective equipment, such as eye protection, is worn.
• Injuries due to a defective diamond cutting wheel.
Check the integrity of the diamond cutting wheel
regularly.
• Danger of injury for fingers and hands when chang-
ing the cutting wheel. Wear suitable work gloves.
• Danger of injury when the machine is switched on
from the running cutting wheel.
• Hazard due to electrical power, with the use of im-
proper electrical connection cables.
www.scheppach.com GB | 31