Scheppach HSM3500 Originalbetriebsanleitung Seite 28

• The machine with the offered tool and accessories
is exclusively designed for the cutting of tile and
concrete blocks with a cutting height of up to 110
mm. The cutting of metal and wood is not permitted.
• Do not exceed or not reach the maximum and mini-
mum dimensions of the workpieces to be machined.
• Only use the machine when in a technically faultless
condition, appropriately and in compliance with the
operating manual and with full knowledge of safety
and hazards! In particular, rectify malfunctions that
could impair safety immediately (or commission rec-
tification works accordingly)!
• The safety, operating and maintenance specifica-
tions of the manufacturer, as well as the dimensions
specified in the technical data, must be observed.
• Relevant accident prevention regulations and oth-
er generally recognized safety and technical rules
must also be observed.
• The machine may only be used, maintained or re-
paired by persons who are familiar with it and have
been informed of the dangers. The manufacturer
shall not be liable for damage resulting from unau-
thorised changes to the machine.
• The machine may only be operated with original ac-
cessories and original tools from the manufacturer.
Despite use as intended, specific risk factors cannot
be entirely eliminated. Due to the design and layout of
the machine, the following risks remain:
• Reaching into the running diamond cutting wheel.
• Contact with the diamond cutting wheel in the un-
covered area.
• Ejection of workpieces and workpiece parts.
• Ejection of a faulty diamond attachment of the cut-
ting wheel.
• Hearing damage when the necessary hearing pro-
tection is not used.
• Injury to the eyes when eye protection is not used
Any use beyond this is improper use. The manufac-
turer is not responsible for the resulting damages; the
user solely bears the risk.
Please note that our equipment was not designed with
the intention of use for commercial or industrial purpos-
es. We assume no guarantee if the device is used in
commercial or industrial applications, or for equivalent
work.
28 | GB
5. Safety instructions
Working with the stone and tile cutter can be danger-
ous if the correct and safe working procedures are
not followed. As with all machines, working with the
product involves certain risks. Treating the machine
with respect and caution will significantly reduce the
danger of injury. If the usual safety measures are ig-
nored, this may result in injury to the operator. Safety
equipment such as protective devices, safety goggles,
dust masks and hearing protection can reduce the
danger of injury. However, even the best protection
is no match for miscalculation, carelessness or inat-
tention. Always use common sense and caution in the
workshop. If a procedure feels dangerous, don't try it.
Consider an alternative approach that feels more se-
cure. Remember: Your physical safety is your personal
responsibility. This machine was designed for certain
jobs.
We strongly recommend that you do not modify the
machine and that you do not use it for applications for
which it was not designed. If you are unsure about any
point, ask your dealer before you start work with the
product.
Warning: Failure to follow these instructions can re-
sult in serious injury.
Attention! The following basic safety measures must
be observed when using power tools for protection
against electric shock, and the risk of injury and fire.
Read and observe these instructions before using the
device.
1. Keep the work area orderly
Disorder in the work area results in risk of acci-
dents.
2. Take environmental influences into account
Do not expose power tools to rain. Do not use pow-
er tools in a damp or wet environment.
Ensure good lighting. Do not use power tools in the
vicinity of combustible fluids or gases.
3. Protect yourself from electric shock
Avoid body contact with earthed parts, for example
pipes, heaters, ovens, refrigerators.
4. Keep away from children!
Do not let other people touch the tool or the cable,
keep them away from your work area.
5. Store your tools safely
Unused tools should be stored in a dry, locked
room and out of reach of children.
www.scheppach.com