Profitec DRIVE Bedienungsanleitung Seite 134

The espresso preparation process starts. If set, the pre-infusion timer
¾
first runs backwards on the display (see Chapter 10.3.4, „Pre-infusion").
The espresso pulling timer then starts. The pump pressure is displayed
on the pump pressure gauge.
7. Once the desired amount of espresso has been poured into the cup,
move the brew lever back into the starting position.
The espresso pulling process is complete. Residual water is drained into
9
the drip tray and residual pressure released via the residual water outlet
of the brew group.
9.11 Removing the portafilter from the brew group

WARNING
Risk of injury due to hot surfaces and liquids spraying out
When removing the portafilter, hot water and coffee grounds may spray out
and cause injuries or scalding.
The stainless steel surfaces of the portafilter become hot when the
portafilter is installed during operation of the machine.
• To end the brewing process, move the brew lever fully into the bottom
position.
• Always operate the portafilter by the black plastic handle.
1. Hold the portafilter with one hand.
2. Turn the portafilter to the left to release the connection.
3. Carefully pull the portafilter out downwards.
9.12 Drawing hot water

WARNING
Risk of injury due to hot surfaces and hot water spraying out
Injuries may occur when drawing water due to the high temperatures of the
water wand.
Hot liquids may spray out and cause injuries or scalding.
• Only operate the hot water wand via the rubber handle.
• Always keep the nozzle of the hot water wand fully inside the receptacle
to be filled.
DRIVE_BA_V3.0 EN - 133