Profitec DRIVE Bedienungsanleitung Seite 117

7.4.2 Additionally required accessories
• Pressure reducer: The water supply often does not remain at a
consistent pressure. If it is possible that the pressure will temporarily
exceed 2 bar, a pressure reducer must be used.
• Shut-off valve: The water supply can be shut off at any time using
a shut-off valve. The shut-off valve must be easily accessible after
installation.
• Wastewater hose with thread, inner diameter 1/2 inch, outer diameter
3/4 inch
• Stainless steel hose clamp
• PVC threaded connection, inner diameter 1/2 - 3/4 inch, outer diameter
3/4 - 1 inch
7.4.3 Connecting the machine to the water supply
1
Fig. 4 Rear view with rotary valve and water connection nozzle
1 Rotary valve in mains water position
2 Water connection nozzle
3 Gasket
1. Disconnect the existing hose from the water supply.
2. Screw the water connection hose (4, Fig. 4) included in the scope of
delivery to the water connection nozzle (2, Fig. 4) on the underside of
the machine. Use the gasket (3, Fig. 4) for this.
3. Install the pressure reducer and shut-off valve (not included in scope of
delivery) at the water supply.
4. Connect the water connection hose (5, Fig. 4) to the water supply.
5. Move the rotary valve (1, Fig. 4) into the mains water position. The valve
points towards the outside of the machine.
6. Activate the mains water mode via the menu (see Chapter 10.4.5, „Tank
Mode").
EN - 116
2 3 4
4 Device-side hose connection
5 Water supply hose connection
5
DRIVE_BA_V3.0