Eko CORE Benutzerhandbuch Seite 7

6. EMC Compliance
FCC Intentional Radiator Certification
FCC ID: 2ANB3-E6
US FCC Statements
47 CFR Part 15.105 required statement for Class B:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Part 15 Clause 15.21
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
FCC Part 15.19(a)
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
RF Exposure Guidance Statement
In order to comply with FCC RF Exposure requirements, this device
must be installed to provide adequate separation from the human
body at all times. Refer to Section 15. Electrical Emission and Device
Specification Tables
Canada regulatory statement(s):
ISED Canada RSS-Gen Notice
IC: 23063-E6
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) This
device may not cause interference; and (2) This device must accept any
interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
7