Detector Keypad; Automatic Sensor Switch-Off; Low Battery Warning - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS
3.8.1

Detector keypad

1
2
RED LED on steady. The sensor is on.
1
RED LED flashing. The sensor battery is low (when the remaining battery charge is lower than or equal to 30%); it will turn off after a few
minutes
2 Control keypad:
Scroll back in program
Scroll up the menu
Sensor power button.
Scroll down the menu
Scroll forward in program
Tap them at the same time to switch off the sensor manually.
GREEN LED. The sensor battery is charging.
3
3.8.2

Automatic sensor switch-off

The sensors automatically switch off after approx. 5 minutes if no data is received, i.e. when the program is at a stage where
measurement data is not transmitted/received (e.g. on the start page) or if the PC is switched off.
It is possible to switch off the sensors manually when they are not used (see the table in para. 3.8.1).
3.8.3

Low battery warning

When the remaining charge of one or more sensors is LESS than or EQUAL to 30%, the programme
displays an error message with details of the charging percentage.
This signal is also emitted on the sensor itself with the flashing of the red power LED (Para. 3.8.1).
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
3
2015-M366-00 EN-83