Viewing The Technical Data Of The Preselected Vehicle - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS
7.5.3

Viewing the technical data of the preselected vehicle

Once the vehicle has been selected (Para. 7.5.1 and 7.5.2), a screen opens with the measurements and tolerances of the angles
(minimum, central and maximum value) and other additional data, such as the rim diameter, wheelbase, track and any load and tank
conditions (*).
The screen with the measurements and tolerances can be displayed as per the image below: with a single column of corresponding
values for the left and right side.
1
2
3
1 Any load and tank conditions
2 Wheelbase and track values in mm
Circle diameter:
3
Note: it is also possible to change the displayed diameter by pressing on the circle symbol.
Front axle angle tolerances
4
Note: use the scroll to view all the data
5 Tolerances of rear axle angles
In the "Settings" menu (Para. 7.2) it is also possible to set separate left and right data displays (some vehicles can have slightly
different tolerance values for the left and right side).
NOTE: The device with the 3D2.0WiFi App contains technical information relating to vehicles, provided through official databases.
Access to the system and information is subject to the reading and acceptance of a Disclaimer, which is shown on the device after
the first use of the APP.
EN-102 2015-M366-00
Tap this key; the measurements can also be displayed with the central value and overall tolerance "±".
Tap this key to continue with the preliminary operations on the vehicle.
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
4
5
Tap to view alternately:
- min/central/max
- central/tolerance "±".