Preliminary Operations; Preliminary Vehicle Check Operations; Run-Out Preparation - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS
7.6

PRELIMINARY OPERATIONS

7.6.1

Preliminary vehicle check operations

Before carrying out the vehicle alignment check, it is necessary to perform a number of preliminary checks:
• Check and if necessary eliminate the play on the suspension and on the steering linkage.
• Check and if necessary eliminate possible hardening or yielding of the elastic parts of the suspensions.
• Adjust the tyre pressure to the values prescribed by the manufacturer.
• Position and distribute any loads envisaged by the manufacturer.
7.6.2

Run-out preparation

1
• Lock the turntables (1).
• Place the front wheels on the turntables (2).
• Mount the clamps and sensors on the wheels (3).
Note: during this step, images representing the 4 sensor batteries are shown, with the relative % of residual charge.
EN-106 2015-M366-00
Once the vehicle's technical data page has been viewed (Para. 7.5.3) tap this key to continue.
The following page appears illustrating the preparation of the vehicle for the run-out procedure.
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
2
3