Sensors - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS
3.8

SENSORS

No cables or cords need to be connected for the sensors to measure the angles.
The detector assemblies consist of infrared data transmitters/receivers and CCD-type transducers with an infrared emitter focal point.
All characteristic angles of both vehicle axles are checked by 8 CCD sensors with infrared measurement. Infrared measurement is
always effective even in critical lighting conditions.
The front sensors communicate directly with the control device (Tablet) via compatible Bluetooth modules.
The data from the rear sensors is transmitted/received by passing through the front sensors, using infrared transmission.
Power is supplied by long-lasting 6V rechargeable batteries. The batteries of the front and rear sensors are recharged on the special
charging stands which can be found on the panel.
ATTENTION
• The rechargeable batteries are contained in a plastic housing. If there are any signs of corrosion, swelling
of the container or damage to the container, the battery must be removed immediately and replaced with
a new, undamaged, original one.
• The batteries must be handled with care. The user must wear protective gloves.
• Do not open or tamper with the battery pack and its shell.
• Use only the supplied battery pack.
• A label with notes and warning symbols is affixed to each battery
WARNING
• Do not cause short circuits and do not disassemble the battery pack.
• Do not expose the battery pack to excessive heat sources
The power and consumption data of the measuring heads with rechargeable battery are as follows:
Power supply
Average operation with battery in full
efficiency and charged
Average charging time
REAR SENSORS
NiMH battery 6V - 2000mAh
Approximately 12 hours
Approximately 10 hours
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
FRONT SENSORS
NiMH battery 6V - 2000mAh
Approximately 10 hours
Approximately 10 hours
2015-M366-00 EN-81