Steering Procedure - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS

7.10 STEERING PROCEDURE

Once the alignment procedure is complete (Para. 7.9), the following screen appears; from here, it is possible to carry out the steering
procedure needed to determine the following angle measurements:
• Caster - King-pin - Incl.angle
Steering arrival point
Tap this key to select
the steering mode (*)
Following the instructions on the screen, turn the steering wheel such as to bring the level of the viewer to the point of arrival highlighted
in green, first to the left, then to the right and finally to the centre.
After the wheels have been returned to the centre, the program proceeds automatically and will show the diagnosis page (Para. 7.11).
(*) Steering mode for acquisition of caster/king-pin.
Steering at 10°
Steering at 20°
ACKERMANN steering (at 20° with steering geometry)
EN-110 2015-M366-00
Note: The steering procedure can also be skipped by selecting this key; the values of the measurements
indicated above will not be obtained, skipping straight to the diagnosis page (Para. 7.11).
Maximum steering:
By selecting this key, the following page appears, where the maximum steering values can be entered
manually. These values are used to assess the centring of the steering box; they are read on the turntable
graduated scale (Para. 3.10).
After entering the values, confirm by tapping this key.
The maximum steering values will be shown on the final printout.
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
Steering level
indicator
Tap this key to skip
the procedure