Dover VSG RAV.TD2WF Übersetzung Der Originalanleitung Seite 124

TABLE OF CONTENTS
Flashing central
key
After the measurement has been acquired, the sensor alignment and levelling operations screen will be displayed again (Para. 7.9):
It will be necessary to level the front sensors again; since measurements with the toe-in transducers at the end of the arm are no
longer necessary (they are acquired with the Spoiler program), the program will proceed to the next step (Para. 7.10).
EN-124 2015-M366-00
The central key of the sensor keypad will flash, indicating that it needs to be pressed again to continue.
When the central key is pressed, it remains displayed for a few seconds in the centre of the page, while
the angle is being measured.
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF