Rear Axle Adjustment - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS

7.13 REAR AXLE ADJUSTMENT

The following screen appears.
Measurements of the
rear camber angles.
Measurements of the
rear partial toes.
Adjustment, where permitted, in the following order:
Rear camber - Rear partial toe (this also determines the thrust angle).
NOTE (*)
If the "adjustment by sound" function has been configured in the "Application" menu (Para. 7.2), by clicking on the desired angle, the
" " indication appears below and a "Beep" sounds with a variable frequency in relation to the value itself.
Beep with very slow frequency
Beep with slow frequency
Beep with fast frequency value in tolerance
Continuous beep
EN-112 2015-M366-00
Tap this key on the screen of Para. 7.12 after preparation for adjustment is complete.
Tap this key to run the "Jack-Hold" procedure, adjustment with the wheels raised (Para. 7.14.1).
Tap this key to view the images (if present) to aid adjustment (Para. 7.5.6).
Tap this key to continue with adjustment of the front axle (Para. 7.14).
value out of tolerance
value near the tolerance
value exactly in the centre of the tolerance
Click on the angle again to delete this indication and deactivate the "Beep".
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
Selection of "adjust-
ment by sound" (*)
Thrust angle
measurements.