Maintenance; Troubleshooting - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS
9

MAINTENANCE

WARNING
• Before carrying out any maintenance work, it is necessary to turn off the main switch and disconnect the equipment
from the mains.
WARNING
• Do not use products that contain substances such as acetone, methyl chloride, ethyl alcohol, ammonia or ethyl acid.
• To clean plastic panels or shelves, use non-aggressive, neutral products. Do not use solvents such as synthetic
thinners, benzene, alcohol or abrasive products as they may damage the surface.
• Do not clean the equipment using water jets.
• Keep the filters of the optical units clean using a slightly damp cloth, do not use solvents;
• Cleaning and other operations relating to maintenance of the Tablet are described in the manual supplied with it.
Always refer to the latter before carrying out any maintenance on the Tablet.
9.1

TROUBLESHOOTING

Listed below are several problems that may be encountered on the wheel aligner equipment.
VSG ITALY S.R.L. disclaims all liability towards persons, animals and property due to intervention by unauthorised personnel and the
use of non-original spare parts.
WARNING
• Before carrying out any work on the system, it is necessary to disconnect the power supply.
• In case of doubt, do not improvise but rather contact VSG ITALY s.r.l. technical support to receive instructions and
carry out the necessary procedures under safe conditions.
PROBLEM
The sensors do not switch on
The sensors are not recharged on the stands
The detectors are not communicating with the
Tablet
EN-128 2015-M366-00
CAUSE
- Battery completely flat.
- No mains voltage.
- Safety fuses interrupted.
- No voltage in the network
- Protection fuses interrupted
- Access Point disconnected from the
network
- Tablet not connected to the Wi-Fi
network
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
SOLUTION
- Recharge battery.
- Check the mains voltage.
- Check the safety fuses.
- Check the mains voltage
- Check the protection fuses
- Connect the Access Point to the
network
- Connect the Tablet to the Wi-Fi
network