Vehicle Diagnosis; Preparing For Adjustment - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS

7.11 VEHICLE DIAGNOSIS

Once the steering procedure is complete (Para. 7.10), a page appears showing a summary of the measurements made.
The part on the left shows the factory reference values, on the right the diagnosis measurements are shown; the values are highlighted
in green if in tolerance, in red if outside the tolerance, in grey if the tolerances are not present.
Factory reference
values

7.12 PREPARING FOR ADJUSTMENT

Follow the directions that appear on the device to prepare for adjustment.
1. Centre the steering
wheel.
2. Mount the steering
holder with the
appropriate tool and
proceed
Tap this key to go back to the steering procedure (Para. 7.10).
Tap this key to go to the vehicle and customer data entry step, where it is possible to print (Para. 7.16),
share the measurements made (Para. 7.17) or save the tests (if TEq-Link is present - Para. 7.18).
Tap this key to display the chassis diagnosis page (Para. 7.15.1).
Tap this key to continue with preparation for the adjustment (Para. 7.12).
Tap this key on the diagnosis measurement summary page (Para. 7.15), a page appears showing the
preparation for adjustment.
Tap this key to continue with adjustment of the rear axle (Para. 7.13).
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
Diagnosis measure-
ments highlighted
2015-M366-00 EN-111