Front Axle Adjustment - Dover Vsg Rav.td2Wf Übersetzung Der Originalanleitung

TABLE OF CONTENTS

7.14 FRONT AXLE ADJUSTMENT

The recommended angle adjustment order is as follows: CASTER - CAMBER - TOE.
NOTE: The incidence values, entering this phase, are "FROZEN" and displayed in grey.
To "UNFREEZE" the above values it is necessary to: Tap "Caster" in the tolerance values; the symbols ">" "<" appear and the key
appears below. Tapping this key, the values turn Red or Green (depending on the tolerance) and the cursor "
appears under the value.
Once the caster values have been recorded, or even if they are not recorded but are deemed as being correct, it is advisable to
"REFREEZE" the afore-mentioned values by tapping the key
Then perform adjustment of the front axle
Caster measurements
"Frozen" values
displayed in grey.
Front camber
measurements.
Front partial toe
measurements.
Adjustment, where permitted, in the following order:
• caster - front camber - front partial toe
Tap this key on the screen of para. 7.13 after preparation for adjustment is complete.
Tap this key to run the "Jack-Hold" procedure, adjustment with the wheels raised (Para. 7.14.1).
Tap this key if there are images to aid adjustment (Para. 7.5.6)
Tap this key to go to the DIAGNOSIS and ADJUSTMENT data summary (Para. 7.5).
again.
RAV.TD2WF
ROT.TD2WF
SPA.TD2WF
"
Incidence Measurements
highlighted with ">" "<"; the
unfreeze/freeze key
is available.
Sound associated during
adjustment (see Note in
Para. 7.13).
2015-M366-00 EN-113