Gastroback ADVANCED CONTROL Bedienungsanleitung Seite 47

Problem Possible Reason
No respond to the buttons Restart button: the
or the browning control appliance is still pre-
dial. heating.
Menu button and
browning control
dial: a program is run-
ning or the manual control
"CUSTOM" is activated.
Your waffles are not done, An unsuited program is
after the baking time selected.
elapsed.
The waffles are too dark, You used an insufficient
hard, and/or dry. program.
The browning level is set
too dark.
The waffles stick to the The non-stick coating has
waffle plates. not been prepared for
operation.
The appliance did not
reach the required start
temperature, when you fil-
led in the waffle batter.
The waffles are not done.
The baking time is too
short.
EN
92
The Easy Solution
The baking cycle cannot be started during pre-heating.
Wait until the required temperature is reached and the
browning indicator dashes illuminate continuously.
After starting a program or the manual control
("CUSTOM") no other program can be selected and the
browning control dial is deactivated. After starting a pre-
defined program: Wait until the program is finished. After
activating manual control ("CUSTOM") via starting the
baking time: switch off the appliance shortly via the power
button. When switching on thereafter, all settings are
available again.
- Close the lid again and leave the waffles bake for some
more seconds, and/or
- Select another program and/or
- Select a darker browning level and/or
- Use the manual control "CUSTOM" and bake the batter
for an appropriate time.
Note: When using whole meal instead of plain flour for
your waffle recipe, the required baking time may differ
significantly.
Select another program with a shorter baking time.
Select a lighter browning via the browning control dial.
Switch of and unplug the appliance. Leave the appliance
cool down sufficiently and clean the appliance. Thereafter
rub the waffle plates with some droplets of cooking oil ,
before using the appliance again.
Before filling in the batter, always wait until the browning
indicator dashes do not flash any longer.
Close the lid and leave the waffles bake for some more
seconds. However, consider that baking waffles is a mat-
ter of only a few minutes and seconds. Do not leave
the waffles within the appliance for a too
long time. Otherwise your waffles may burn.
Problem Possible Reason
The non-stick coating is
damaged.
CARE AND CLEANING
WARNING - RISK OF BURNS
is out of reach of young children. Before moving, disassembling, or cleaning the
appliance: Always switch OFF the appliance (press the power button, the LCD
display gets dark), then unplug the appliance, and wait until the appliance cooled
down completely (at least 30 minutes with the lid open). Do not move the appli-
ance with the waffle plates still hot to avoid injuries and damage.
WARNING
– Do not immerse or place the appliance or power cord in
water or other liquids. Do not drip or pour any liquids on or into the housing of the
appliance. The appliance may not be used again, when water has run into the
interior of the housing (lid or base). Do not place the appliance or any part of
it in an automatic dishwasher! Do not use violence.
CAUTION
– The waffle plates, moat and hinge of the appliance are equip-
ped with non-stick coatings. Do not use any abrasive cleaners or corrosive chemi-
cals (e.g. bleach, oven cleaner) for cleaning the appliance or any parts of it, to
avoid damage to the surfaces. Do not use any hard or sharp-edged objects for
cleaning any surface of the appliance.
CAUTION
– Do not place the appliance or any part of it on surfaces that
are sensitive to heat, fat or moisture.
Before moving the appliance by the handle of the lid, always ensure that the locking
clip is in the vertical closed position and engaged firmly at the lock jut (see: 'Proper-
ties of Your New Waffle Maker / Locking the Lid to the Base').
Clean the appliance after each use to avoid that residues of food dry on the surfaces
and burn to charcoal, when using the appliance again. Cleaning may be easier,
when the appliance is still lukewarm.
1. Before cleaning, always ensure that the appliance is unplugged, and cooled
down sufficiently (at least 30 minutes with the lid open). Clean the waffle plates
The Easy Solution
Do not use the appliance with the non-stick coating
damaged (e.g. excessively worn, scratched, or deta-
ched and/or deteriorated due to overheating). Do not
scratch or cut on the non-stick coating!
– Always ensure that the appliance
EN
93