ECOLAB EcoTrans II pH Betriebsanleitung Seite 83

8 Operation
8.1 Key functions
Fig. 6: Keypad
As soon as the "Mode" button
current output are switched off.
If no button is pressed for two minutes, operating mode is automatically
reactivated and the relay outputs and the control current output are switched
on.
8.2 Display at operating level
The display in the operating level of the EcoTrans II depends on the function type set in
the menu 'CONFIGURATION è Current mode ' :
Ä Chapter 8.8.1 'Setting the function type (Current mode)' on page 42
n 'Transducer'
n 'Control Output'
2 3
1 4
Select the setting mode
n
n Return from a setting level to setting mode
n Return to operating mode
Select setting level
n
n Select setting values
n Apply the selected setting level
Confirm the selected value
n
(the ability to set a value is indicated by the character * on the right of the top line
of the display)
Ä
'Display for function type 'Transducer' ' on page 28
Ä
'Display for function type 'Control Output' ' on page 28
"Mode" button
1
"Down" button
2
"Up" button
3
"OK" button
4
is pressed, the relay outputs and the control
27
Operation
MAN052993 Rev 2-01.2024