ECOLAB EcoTrans II pH Betriebsanleitung Seite 85

Menu structure for function type 'Transducer'
In the function type 'Transducer' , the device records measured values in the
range 0–14 pH and converts them into a standard signal of 0–20 mA or 4–20
mA.
CALIBRATION
STOP CONTR.
RELAY CONFIG.
CONFIGURATION
Fig. 9: Menu structure for function type 'Transducer'
Press to move from any setting menu to the next higher level.
1
2
3
4
1
2
3
4
29
Ä Chapter 8.4 'Perform calibration' on page 31
Ä Chapter 8.5 'Stopping the controller' on page 34
Ä Chapter 8.7 'Configuring relays (only for function
type 'Transducer' )' on page 39
Ä Chapter 8.8 'Configuration' on page 40
MAN052993 Rev 2-01.2024
Operation