ECOLAB EcoTrans II pH Betriebsanleitung Seite 82

Start-up
7 Start-up
Personnel:
Protective equipment:
7.1 Initial start-up
Requirements:
n The unit is mounted and fully connected
1.
Switch on the power supply.
2.
Set the operating mode.
on page 42
3.
Set additional measurement and control parameters.
on page 40
4.
Perform calibration.
MAN052993 Rev 2-01.2024
n Service Personnel
n Qualified employee
Protective goggles
n
n Chemical resistant protective gloves
Ä Chapter 8.8.1 'Setting the function type (Current mode)'
Ä Chapter 8.4 'Perform calibration' on page 31
26
Ä Chapter 8.8 'Configuration'