ECOLAB EcoTrans II pH Betriebsanleitung Seite 67

2 Safety
2.1 General safety advice
DANGER!
If you believe that the unit can no longer be operated safely, you must
decommission it immediately and secure it so that it cannot be used
inadvertently.
This applies:
– if the unit shows visible signs of damage,
– if the unit no longer appears to be operational,
– after prolonged periods of storage under unfavourable conditions.
The following instructions must always be observed:
– Prior to carrying out any work on electric parts, switch off the power supply
and secure the system against being switched back on again.
– Safety regulations and prescribed protective clothing when handling
chemicals should be followed.
– Attention must be paid to the information included on the product data
sheet of the metering medium used.
– The unit must only be operated with the supply and control voltage
specified in the Technical Data section.
2.2 Intended use
The EcoTrans II pH is used only used to determine and control the pH value in validated
chemicals. Use is restricted to commercial applications in an industrial environment;
private use is excluded.
Intended use also includes compliance with the control and operating
instructions prescribed by the manufacturer, as well as with the maintenance
and servicing conditions.
Reasonably foreseeable incorrect use
To maintain proper function, pay attention to actions that could result in foreseeable
incorrect use according to the risk analysis conducted by the manufacturer.
n Use of dosing media other than those validated by the manufacturer.
n Change in the permitted dosing specifications of the dosing media.
n Operation on unsuitable power supplies.
n Incompatible accessory parts.
n Incorrect ambient temperatures or media temperatures.
11
Safety
MAN052993 Rev 2-01.2024