Heidolph Hei-VAP Core Betriebsanleitung Seite 99

Assembly
Inlet tube 1
➜ Shorten the supplied PTFE tube so
that the end of the tube ends in the
evaporating flask.
➜ Slide the drain disk onto the PTFE tube
so that it is positioned before the vapor
tube of the evaporator flask.
✓ This prevents condensed fluid from
flowing back into the evaporating flask
via the inlet tube.
➜ Unscrew the screw cap from the
condenser.
➜ Slide the seal ring and screw cap about 3
cm onto the PTFE tube.
➜ Insert the inlet valve with the inlet tube into the inlet opening of the condenser and
tighten the screw cap.
Inlet tube 2
➜ Slide the PTFE tube onto the inlet
opening.
✓ The inlet hoses are installed.
Inlet hoses Glassware set G1
The opening for the inlet tubes is located at
the top of the condenser.
Inlet valve
Screw cap
Ventilation cap
Inlet valve
Opening fore inlet tube 2
G1: Screw cap inlet tube 1
Opening fore inlet tube 2
99
Drain disk
Vapor tube
Inlet tube 1