Heidolph Hei-VAP Core Betriebsanleitung Seite 66

Start-Up
Connecting/disconnecting the power cord

Connecting the power cord
The power cord has a three-pole
connector. and has a recess on its bottom
side.
The device socket is located on the rear of
the device.
➜ Insert the power cord connector into
the device socket with the recess
pointing downwards.
✓ The connector has been securely
inserted when it has been pushed in
up to the stop.
➜ Now insert the power cord plug into
the power socket.
Disconnecting the power cord
➜ First, remove the plug from the power socket.
➜ Then disconnect the power cord connector from the device.
Transportsicherung entfernen

Caution:
Possible damage to the device (motorlift variants only)
Switching the device on before the heating bath and the control panel
are connected can cause malfunctioning of the electronics the moment
the transportation lock is removed.
Prior to switching on the device for the first time, remove the
transportation lock exactly in the order given in the instructions (see
chapter "Assembly", section "Transportation lock").
Switching the device on and off

The ON/OFF switch is located at the lower
left side of the device.
Switching the device on
➜ Press the ON/OFF switch on the left
side.
✓ The currently set values will appear on
the display.
✓ The device is switched on.
Start-Up
Power cord connector
ON/OFF switch: OFF
66
Power cord
Device socket