Heidolph Hei-VAP Core Betriebsanleitung Seite 71

Operation
Menu navigation

The initial screen displays the current actual values. Use the rotary knobs to set the
parameters Rotation and Temperature for distillation.
✓ The device is switched on.
➜ Turn the rotation knob or the
temperature knob to set the desired
value.
✓ The setpoints are shown in the display
and designated as "set".
✓ If no further action is taken, the display
changes after few seconds and shows
the current actual values again.
✓ Pressing the respective rotary knobs
will start the heating and the rotation.
✓ When rotation is switched on, the
rotation knob lights up with a white
illuminated ring.
✓ With heating switched on, the tempe-
rature knob lights up with an orange
illuminated ring.
✓ The heating function is indicated by a
heating symbol next to the temperature
display.
✓ Press the rotary knobs again to switch off the heating or the rotation.
➜ Press the setpoint button "show set" to show the setpoints in the display. The setpoint
display is designated with "set".
➜ Press the Standby button at the bottom right to switch the standby mode on and off.
Warning:
Possible unwanted parameter changes
As long as the display and the rotary knobs are active, parameters
may be changed unintentionally.
If the device is to be operated without surveillance only leave when
the rotary knobs and the display are locked (see chapter " Operation,
Protecting setpoints").
"set" displays the setpoints
Rotation knob
Rotation switched on Heating switched on
71
Temperature knob