Heidolph Hei-VAP Core Betriebsanleitung Seite 89

Assembly
Condenser: Glassware set G6
(Cooler for reflux distillation)
Additional assembly parts at the
vapor tube:
▪ PTFE seal sing
▪ Spacer sleeve
▪ Additional coupling
✓ The vapor. tube is installed together
with the PTFE seal.
➜ Install the PTFE seal ring in the spacer
sleeve.
➜ Install the spacer sleeve together with
the PTFE seal ring with the narrow
side first in the vapor tube on the
condenser side.
➜ Screw the additional coupling over it
with the male thread pointing left.
➜ Tighten the distributor with the
coupling including the tension spring
onto the male thread.
✓ The distributor is installed.
➜ Insert the condenser into the upper
ground glass joint on the distributor.
➜ Screw the ventilation cap onto the
opening opposite the vapor tube.
Spacer sleeve
PTFE seal sing
Distributor
Distributor
89
Additional coupling
Ventilation cap