Heidolph Hei-VAP Core Betriebsanleitung Seite 95

Assembly
Connecting vacuum
To connect the vacuum, you need:
▪ a vacuum source
▪ a vacuum tube (Ø 7-8 mm inside)
Glassware sets G1, G3, G3 XL and G6
The opening for the vacuum connection
is located on the back and top of the
condenser.
➜ Unscrew a screw cap with the tube
nipple.
➜ Push the vacuum tube onto the tube
nipple.
➜ Tighten the screw cap with the tube
nipple and the tube.
➜ Connect the other end of the vacuum
tube with your vacuum source.
Glassware set G5
The opening for the vacuum connection
is located on the back and top of the
condenser.
Warning:
Risk of implosion, risk of poisoning
Glass flasks with even the finest damage may burst and, depending
on the sample, the ambient air may be poisoned.
Do not increase the vacuum pressure unless necessary.
Never exceed the permissible pressure of your distillate.
Vacuum connection G1, G3, G3 XL and G6
Screw cap vacuum connection
Vacuum connection G5
Opening vacuum connection
95