Welding Current I; Pulse Time T - REHM INVERTIG.PRO COMPACT 240 DC Betriebsanleitung

Functional description
Current I
1
Current I
2
0
3.5.6

Welding current I

Setting of the welding current I
The range that can be set for the welding current I
mode and the type of machine.
With the press and rotate button [27] the following values can be set according to
the selected welding procedure:
INVERTIG.PRO
COMPACT
240 DC / AC/DC
TIG
3 A ...240 A
3.5.7 I

pulse time t

1
Setting of the I pulse time t
1
welding with pulse function can be divided into two types:
3. Conventional pulses with pulse times between 0.1 ... 5.0 seconds
4. High-frequency pulses with pulse frequencies between 10 Hz... 15 kHz
With the press button [21] you can select the welding procedures conventional
pulsing and high-frequency pulsing (see Chapter 3.8).
When TIG pulse welding, obviously, during the welding process it constantly
switches between the currents I
which current is the greater high current and which is the smaller low current.
Figure 3 displays the current procedure when pulsing.
I -Pulse time t
1
Figure 3: Welding current when pulsing
Whilst welding, pressing the torch button 2 switches the pulsing off and back on
again. If torch button 2 is pressed when pulse welding current is active, the
pulsing is switched off and you can continue welding using welding current I
This can be used, for example, to use the lower welding current I
additional material can be introduced, and pulse welding is reactivated by
pressing torch button 2 again.
Conventional pulsing: Pulsing with pulse time from 0.1 to 5.0 seconds
The settings of I pulse time t
1
that the currents I and/or I
1
digital display always shows the welding current that is currently being output.
The times and welding current levels should be selected in such a way that the
basic material is melted during the high current phase and re-solidifies during the
low current phase. The TIG pulse welding makes the welding bath much easier
1
[7] is carried out as described in Chapter 3.5.1.
1
depends on the set operating
1
INVERTIG.PRO INVERTIG.PRO
COMPACT COMPACT
280 DC / AC/DC 350 DC / AC/DC
3 A ...280 A 3 A ...350 A
1
[8] is carried out as described in Chapter 3.5.1. TIG
1
and I . In addition, it can be freely selected
1 2
I -Pulse time t
1 2
and I pulse time t
1 2 2
are active until switched to the other current.. The
2
INVERTIG.PRO
COMPACT
450 DC / AC/DC
3 A ...450 A
2
Time
until a new
2
determine the length of time
GB
.
2
19