Torch Functions For Quickly Setting Welding Currents I 1 And I; Setting The Welding Current I 1 And I With The Up/Down Torch; Additional Functions - REHM INVERTIG.PRO COMPACT 240 DC Betriebsanleitung

34
3.14

Additional functions

3.14.1 Torch functions for quickly setting welding currents I
and I
2
Setting the welding current I
Briefly pressing (< 0.5 seconds) the torch button 1 selects the option for welding
current I (LED [7] flashes). In the digital display [26] the value for the welding
1
current I is displayed. Rotating the press and rotate button [27] changes the
1
value for I .
1
Pressing the torch button 1 already allows, depending on the setting, HF
ignition impulses to be output.
Setting the welding current I
Briefly pressing the torch button 2 selects the option for welding current I
[9] flashes). In the digital display [26] the value for the welding current I
displayed. Rotating the press and rotate button [27] changes the value for I
After no changes are made to the welding current I
machine jumps back to the previously selected welding parameter. The activation
is possible from every welding parameter, for example, when gas post-flow is
selected.
3.14.2 Setting the welding current I
torch
For this purpose special parameter SP2 must be set to "1" (see Chapter 3.13
Special parameters).
The Up/Down torch can be used to regulate the currents I
before and during welding. The set value is displayed in the digital display [26].
The up and down regulation of I
welding current I flashes during this process).
1
The up and down regulation of I
pressing torch button 2 (LED for welding current I
is regulated up and down by pressing Up/Down.
During welding, the current I
If no Up/Down is pressed for 2 seconds, the machine jumps back to I
lights).
If, during pulsing, the welding current I
the value for welding current I
thus the percentage ratio of I
initial values I = 100A, I
1
(prior to start of welding)
1
(prior to start of welding)
2
1
is carried out by pressing Up/Down (LED for
1
requires welding current I
2
or I that is currently active is regulated up or down.
1 2
is switched up or down using Up/Down
1
is changed to maintain the same relationship,
2
to I when I is changed remains the same (e.g.
2 1 1
= 50A results in end values of I
2
Functional description
or I for 2 seconds, the
1 2
and I with the Up/Down
2
, I up and down, both
1 2
to be selected by
2
flashes during this process). I
2
= 200A, I = 100A).
1 2
1
(LED
2
is
2
.
2
2
(LED [7]
1