Foot Remote Control P1 Isystem; Handheld Remote Control P2 12-Pin (Analog); Water Cooling With Centrifugal Pump And Energy Management Option - REHM INVERTIG.PRO COMPACT 240 DC Betriebsanleitung

38
4.2

Foot remote control P1 iSystem

REHM part number: 7531021
With the foot remote control P1 iSystem (see Chapter 4.1 – Overview) the
welding current can permanently be adapted during welding according to the
application task, using the foot pedal. The current set at the machine is the one
used when the pedal is pressed to the maximum. Based on tolerances of the foot
remote control in it´s initial range, the display value in the lower area can differ
from the welding current.
The remote foot control is connected to the 7-pin remote control socket on the
front of the INVERTIG.PRO COMPACT.
4.3 REHM TIG torch
The TIG torches (see Chapter 4.1. – Overview) are designed to work with the
electronic components of the INVERTIG.PRO COMPACT. They offer a wide
range of options for setting the current source remotely (see Chapters 3.14.1,
3.14.2 and 3.14.3). The use of other TIG torches with remote control can lead to
functional disruptions or cause defects to the INVERTIG.PRO COMPACT.
CAUTION: When using TIG torches with remote control of any type not
specifically recommended by REHM, the guarantee claim is voided.
4.4

Handheld remote control P2 12-pin (analog)

REHM part number: 7531023
The handheld remote control P2 12-pin (analog) (see Chapter 4.1 – Overview)
can be used to reduce the welding current set at the machine by between 0 %
and 100 %. This remote is suitable for MMA welding. This option cannot be used
for TIG welding as the torch button connector cannot be connected and thus it is
not possible to ignite the arc.
4.5 Water cooling with centrifugal pump and energy
management option
REHM part number: 1480010
This option includes a centrifugal pump with flow rate and temperature
monitoring. With the INVERTIG.PRO COMPACT 240 DC to 280 AC/DC, the
cooling power also increases to 2000W.
Accessories and Options