Emerson FOUNDATION Fieldbus Interface Bedienungsanleitung Seite 3

Safe Use Instructions – F
F
OUNDATION
Figure 1. F
OUNDATION
Use this safe use instructions (SUI) document with the
F Fieldbus Interface Instruction Manual
OUNDATION
(Form A6259). For full cautions and descriptions of
installation and troubleshooting procedures, refer to the
manual. If you require training for this product, contact
your local sales office.
The Foundation Fieldbus Interface (or "FFI") with ATEX
approval may be ordered with the H1 Segment modules
described in the technical specification F
Fieldbus Interface (ROC800-Series) (ROC800:FFI).
FFI Special Conditions for Safe Use
Install the equipment in an IP54 or better enclosure
or equivalent location. Any enclosure shall be
suitably certified or otherwise approved for the zone
of use (Zone 2).
The user shall ensure that the rated input voltage is
not exceeded in service.
Declaration of Conformity
Hereby, Remote Automation Solutions declares that the
Foundation Fieldbus Interface products are in
compliance with the essential requirements and other
relevant provisions of European Directives 2004/108/EC
(EMC) and 1994/9/EC (ATEX).
Remote Automation Solutions
Website: www.EmersonProcess.com/Remote
OUNDATION
™
Fieldbus Interface (ROC800-Series)
Fieldbus Interface Label
OUNDATION
Fieldbus Interface
When installing units in a hazardous area,
make sure all installation components
selected are labeled for use in such areas.
Installation and maintenance must be
performed only when the area is known to be
non-hazardous. Installation or maintenance in
a hazardous area could result in personal
injury or property damage.
Always turn off the power to the Foundation
Fieldbus Interface before you attempt any
type of wiring. Wiring of powered equipment
could result in personal injury or property
damage.
To avoid circuit damage when working
inside the unit, use appropriate electrostatic
discharge precautions, such as wearing a
grounded wrist strap.
Check the input power polarity before
connecting power to the Foundation Fieldbus
Interface.
The following tools are required for installation,
maintenance, and troubleshooting:
Personal computer running Microsoft
2000 (with Service Pack 2), Windows XP, or
Windows Vista.
™
ROCLINK 800 Configuration Software.
Phillips-head screwdriver.
Flat-head screwdriver.
Form A6296
September 2011
® ®
Windows