4
Operation
4.1
Safety
Commission the drilling-milling machine only under the following conditions:
The drilling-milling machine is in proper working order.
The drilling-milling machine is used as intended.
The operating manual is followed.
All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the drilling-milling machine immediately in
the event of any abnormality in operation and make sure it cannot be started up accidentally or
without authorisation.
"For your own safety during operation" on page 75
4.2
Control and indicating elements
2
3
Pos.
Designation
1
Cover of draw-in rod
Table feed
3
"Operation table feed V99" on page 105
5
Crank for height adjustment of the drill-mill head
7
Spindle sleeve lever
9
Activation quill feed
Version 1.1.8 - 2021-7-29
6
4
5
Img.4-1: MB4P ǀ MB4PV
Translation of original instructions
1
9
8
7
Pos.
Designation
2
Control panel
4
Spindle protection
6
Selector switch for reduction stage
8
Fine adjustment of spindle sleeve
MB4P ǀ MB4PV
EN
89