Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.3
Switching on the drilling-milling machine
ATTENTION!
Wait until the drilling-milling machine has come to a complete halt before changing the
rotation direction using the rotation direction switch.
CAUTION!
Remove the crank handle
Two speed stages are available for each rotation direction.
Set the mode selector switch
Switch the control on.
Select the desired operating mode
Press the button spindle run "ON". The drilling-milling machine switches on and turns in the
preselected rotation direction.
"Adjusting the rotational speed" on page 92
4.4
Switching off the drilling-milling machine
CAUTION!
Only press the emergency-stop button in a genuine emergency. You should not use the
emergency-stop button to stop the machine during normal operation.
Press the button "O", or switch the operating mode
Set the direction lever for the table feed to the neutral center position.
4.5
Resetting an emergency stop situation
CAUTION!
Set the direction lever for the table feed to the neutral center position.
Unlock the emergency stop switch again.
Switch on the spindle rotation again.
4.6
Power failure, Restoring readiness for operation
CAUTION!
Set the direction lever for the table feed to the neutral center position.
Switch on the spindle rotation again.
4.7
Insert tool
4.7.1
Installation
CAUTION!
When milling operations are performed the cone seat must always be fixed to the draw-
in rod. All cone connections with the taper bore of the work spindle without using the
draw-in rod is not allowed for milling operations. The cone connection should be
released by the lateral pressure. Injuries may be caused by parts flying off.
Version 1.1.8 - 2021-7-29
5
when you use the electric height adjustment.
15
first in the neutral position (0).
16
15
.
Translation of original instructions
15
to the neutral position.
MB4P ǀ MB4PV
EN
91
Werbung
Inhaltsverzeichnis
