Additional Requirements Regarding The Qualification; Operator Positions; Safety Measures During Operation; Safety Devices - Optimum Opti mill MB 4P Betriebsanleitung

have read and understood the operating manual,

be familiar with all safety devices and regulations,

be able to operate the machine.

1.6.5

Additional requirements regarding the qualification

Additional requirements apply for work on electrical components or equipment:
Must only be performed by a qualified electrician or person working under the instructions

and supervision of a qualified electrician.
Before starting work on electrical parts or operating agents, following measures are to be
performed in the following order:

disconnect all poles

secure against restarting

check that there is no voltage
1.7

Operator positions

The operator's position is in front of the drilling-milling machine.
1.8

Safety measures during operation

CAUTION!
Risk due to inhaling dusts and mist hazardous to health.
Dependent on the material which need to be processed and the used auxiliaries dusts
and mist may be caused which might impair you health.
Make sure that the generated health hazardous dusts and mist are safely sucked off at
the point of origin and is dissipated or filtered from the working area. To do so, use a
suitable extraction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Before processing inflammable materials (e.g. aluminium, magnesium) or using inflammable
auxiliary materials (e.g. spirit) it is necessary to take additional preventive measures in order to
safely avoid health risks.
1.9

Safety devices

Use the drilling-milling machine only with properly functioning safety devices.
Stop the drilling-milling machine immediately if there is a failure on the safety device or if it is
not functioning for any reason.
It is your responsibility!
If a safety device has been activated or has failed, the drilling-milling machine must only be
used if you
the cause of the fault has been eliminated,

have verified that there is no danger resulting for the personnel or objects.

WARNING!
If you bypass, remove or deactivate a safety device in any other way, you are
endangering yourself and other staff working with the drilling-milling machine. The
possible consequences are:

injuries due to components or parts of components flying off at high speed,

contact with rotating parts,

fatal electrocution,
EN
MB4P ǀ MB4PV
72 Translation of original instructions Version 1.1.8 - 2021-7-29