Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.12
Drill-Mill head
4.12.1 Height adjustment
The height can be adjusted by hand crank or via the motor for height adjustment.
ATTENTION!
Damage to the engine and/or other components. The height adjustment is not designed
for drilling or milling.
4.12.2 Drill depth stop
Use the drilling depth stop (25) when drilling several holes of the same depth.
Img.4-7: "Threading" on page 99
4.12.3 Automatic spindle sleeve feed
ATTENTION!
The higher the preset number of revolutions, the greater the feed speed in the sleeve.
Make sure to use the correct speeds depending on the used material and on the drill
diameter.
Img.4-4:
milling head for automatic quill feed
INFORMATION
The maximum path of the drill depth stop is a full revolution of the scale ring (33).
Set the feed rate (28).
Activate the automatic spindle sleeve feed (26).
Loosen the clamping lever (32) of the sleeve.
Set the drill depth stop with scale ring (33) and the clamping lever (30).
Loosen the knurled screw for the prevention of automatic quill feed.
Drag the spindle sleeve lever (29) to right.
EN
MB4P ǀ MB4PV
96
26
27
26
27
28
28
29
29
30
30
31
32
33
31
32
33
Translation of original instructions
Automatic spindle sleeve feed selector
Clamping lever drill-mill head
Selector switch for speed of feed
0.1 mm/rev
0.18 mm/rev
0.26 mm/rev
Spindle sleeve lever
Clamping lever scale ring
Knurled screw for automatic quill feed prevention
Clamping lever for sleeve
Scale ring drill depth
Version 1.1.8 - 2021-7-29
Werbung
Inhaltsverzeichnis
