The Main Menu; Lcd Display Parameter Setting - Optimum Opti mill MB 4P Betriebsanleitung

4.15.4 The main menu

In the normal display state, press and hold the "PROG" key for three seconds to enter the main
menu.
LCD display setting
LCD display setting: the secondary menu, press "PROG" key to enter to modify the LED
display parameter.
Unit selection
Press "PROG" key to enter the menu, mm/inch as a select.
Language selection
Press "PROG" key to enter the menu, English/German as a select.
Working mode
Press "PROG" key to enter and select,
X Y/Z0 Z

Standard display
X Z+Z0 Z

for lathes, Z / Z0 axis overlay display, Sum of bedslide + top slide
2X Y/Z0 Z

for lathes, duplicate value in the X axis display.
Decimal point
Selection of decimal places, 2 or 3 decimal places.
Channel setup
Multilevel menus, press the "PROG" key to enter the menu, to modify X Y Z as well as the
speed axial parameter.
Operation
The introductions of the main functions.
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to the normal display
state.

4.15.5 LCD display parameter setting

Contrast
Press the "PROG" key to enter the menu, selection range is 0~31, the increment or decrement
is 1.
Backlight
Press the "PROG" key to enter the menu, selection range is 0~63, the increment or decrement
is 1.
Test sample
Selection of three different RGB display types.
Press the "PROG" key to enter the menu, selection range is 0~3, the increment or decrement is
1.
Save and Exit
Saving new parameter, press "PROG" key to confirm, then return to the main menu.
GB
DRO 5
102 Translation of original instructions Version 1.1.8 - 2021-07-29