Maintenance; Safety; Preparation; Restarting - Optimum Opti mill MB 4P Betriebsanleitung

5

Maintenance

In this chapter you will find important information about
Inspection

Maintenance

Repair

of the drilling-milling machine
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for

operational safety,

failure-free operation,

long service life of the drilling-milling machine and

the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1

Safety

WARNING!
The consequences of incorrect maintenance and repair work may include:

Very serious injury to personnel working on the,

Damage to the drilling-milling machine.
Only qualified personnel should carry out maintenance and repair work on the drilling-
milling machine.
5.1.1

Preparation

WARNING!
Only carry out work on the drilling-milling machine if it has been disconnected from the
mains power supply.

"Switching-off and securing the drilling-milling machine" on page 75
Attach a warning sign.
5.1.2

Restarting

Before restarting, run a safety check.

"Safety check" on page 74
WARNING!
Before starting the drilling-milling machine, you must check that there is no danger for
persons and that the drilling-milling machine is not damaged.
5.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
EN
MB4P ǀ MB4PV
106 Translation of original instructions Version 1.1.8 - 2021-7-29