Safety; Rating Plates - Optimum Opti mill MB 4P Betriebsanleitung

1

Safety

Glossary of symbols
provides further instructions


calls on you to act
enumerations

This part of the operating instructions
explains the meaning and use of the warning notes included in these operating instructions,

defines the intended use of the milling-machine.

points out the dangers that might arise for you or others if these instructions are not

observed,
informs you about how to avoid dangers.

In addition to these operation instructions, please observe
the applicable laws and regulations,

the statutory provisions for accident prevention,

the prohibition, warning and mandatory signs as well as the warning labels on the milling-

machine.
When installing, operating, maintaining and repairing the milling-machine it is necessary to
observe the European standards.
If European standards have not yet been incorporated in the national legislation of the country
of destination, the specific applicable regulations of each country must be observed.
If required it is necessary to take the corresponding measures to comply with the country-
specific regulations before commissioning the milling-machine.
Always keep this documentation close to the milling-machine.
If you would like to order another operating manual for your machine, please indicate the serial
number of your machine. Please find the serial number on the rating plate.
1.1

Rating plates

Version 1.1.8 - 2021-7-29 Translation of original instructions
MB4P ǀ MB4PV EN
65