Separating Protective Equipment; Safety Check - Optimum Opti mill MB 4P Betriebsanleitung

1.9.3

Separating protective equipment

Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that the
cover is closed.
INFORMATION
You cannot start the machine if the spindle
protection is not closed.
1.10

Safety check

Check the drilling-milling machine in regular intervals.
Check all safety devices
before each operation,

once a week (with the machine in operation),

after all maintenance and repair work.

General check
Equipment
Protective covers
Signs,
Markers
Functional check
Equipment
EMERGENCY STOP impact
switch
Separating safety device
around the drilling and mill-
ing spindle
EN
MB4P ǀ MB4PV
74
Check
Mounted, firmly bolted and not damaged
Installed and legible
Check
When the EMERGENCY STOP push button is activated, the drilling-
milling machine must switch off. Make sure that it is only possible to
restart the machine if the EMERGENCY STOP push button is unlocked
and the ON switch was activated.
The drilling-milling machine may switch on only when the safety device
is closed.
Translation of original instructions
Img.1-2: Separating
protective equipment
OK
OK
Version 1.1.8 - 2021-7-29