Possible Dangers Caused By The Drilling-Milling Machine; Qualification Of Personnel; Target Group - Optimum Opti mill MB 4P Betriebsanleitung

1.5

Possible dangers caused by the drilling-milling machine

The drilling-milling machine is state-of-the-art.
Nevertheless, there is a residual risk as the drilling-milling machine operates with
at high speeds,

with rotating parts and tools,

electrical voltage and currents.

We have used construction resources and safety techniques to minimize the health risk to
personnel resulting from these hazards.
If the drilling-milling machine is used and maintained by personnel who are not duly qualified,
there may be a risk resulting from incorrect or unsuitable maintenance of the drilling-milling
machine.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,

strictly follow these operating instructions.

Always disconnect the drilling-milling machine from the electrical power supply when
performing cleaning or maintenance works.
WARNING!
The drilling-milling machine may only be used with functional safety devices.
Disconnect the drilling-milling machine immediately, whenever you detect a failure in the
safety devices or when they are not fitted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices.
This is your responsibility being the operating company!

"Safety devices" on page 72
1.6

Qualification of personnel

1.6.1

Target group

This manual is addressed to
the operating companies,

the operators,

the maintenance personnel.

Therefore, the warning notes refer to both, operation and maintenance staff of the drilling-
milling machine.
WARNING!
Disconnect the drilling-milling machine always from the electrical power supply. This will
prevent it from being used by unauthorized persons. The qualifications of the personnel for the
different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks which need to be performed beyond the
operation in standard mode must only be performed by the operator, if so indicated in these
instructions and if the operator has been expressively commissioned by the operating
company.
EN
MB4P ǀ MB4PV
70 Translation of original instructions Version 1.1.8 - 2021-7-29