Swivelling The Drill-Mill Head - Optimum Opti mill MB 4P Betriebsanleitung

4.14

Swivelling the drill-mill head

The milling head may be swivelled to the right and to the left.
ATTENTION!
It is possible to slew the drilling-milling head much further. When slewing it further on
gear oil might escape.
CAUTION!
If the screws are completely unfastened, the drilling-milling head might fall down. When
slewing the drilling-milling head, only unfasten the screws as far as necessary to be able
to perform the settings. After having set the slewing angle, retighten the fixing screws.

Loosen 3 fixing screws.

Turn the drilling-milling head to the desired position.

Retighten the fixing screws.
EN
MB4P ǀ MB4PV
100
35
Translation of original instructions
35 Fixing screw right
left
down
right
Version 1.1.8 - 2021-7-29