Safety Measures During Operation; Safety Devices; Safety Check - Optimum OPTIdrill B 34H Betriebsanleitung

1.8

Safety measures during operation

CAUTION!
Risk due to inhaling of health hazardous dusts and mist.
Dependent on the material which need to be processed and the used auxiliaries dusts
and mist may be caused which might impair you health.
Make sure that the generated health hazardous dusts and mist are safely sucked off at
the point of origin and is dissipated or filtered from the working area. To do so, use a
suitable extraction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Before processing inflammable materials (e.g. aluminium, magnesium) or using
inflammable auxiliary materials (e.g. spirit) it is necessary to take additional preventive
measures in order to safely avoid health risks.
1.9

Safety devices

Use the geared drill only with properly functioning safety devices.
Stop the geared drill immediately if there is a failure on the safety device or if it is not functio-
ning for any reason.
It is your responsibility!
If a safety device has been activated or has failed, the geared drill must only be used if you

have removed the cause of the failure,

have verified that there is no danger resulting for the staff or objects.
WARNING!
If you bypass, remove or override a safety device in any other way, you are endangering
yourself and other persons working on the geared drill. The possible consequences are

injuries may occur due to workpiece or parts of workpieces flying off,

contact with rotating parts,

a fatal electrocution,
The geared drill includes the following safety devices:

an EMERGENCY STOP push button,

a drilling table with T-slots to fix the workpiece or a vice,

a protective cover for the pulleys with positioning switch,

a drill chuck guard, in order to prevent interference with the rotating tool.
WARNING!
The separating protective equipment which is made available and delivered together
with the machine is designed to reduce the risk of workpieces or fractions of them which
being expelled, but not to remove them completely. Always work carefully and observe
the limit values of your chipping process.
1.10

Safety check

Check the geared drill before each start-up or at least once per shift. Inform the person respon-
sible immediately of any damage, defect or change in operating function.
Check all safety devices

at the beginning of each shift (with the machine stopped),
Safety
Version 1.1.3 - 2020-07-21
Abb.1-1:
Translation of the original instructions
Operator positions
B34H | B34HV GB
75