Parameter Setting Of Speed Axis - Optimum Opti mill MB 4P Betriebsanleitung

4.15.8 Parameter setting of speed axis

INFORMATION
Too close or too far away, dirt or grease on the permanent magnets used can cause
reading problems of the sensor.
Teeth amount of every turn (pulses per rev)
Press "PROG" key to enter, selection range is 1~36, the increment or decrement is 1.
Display mode
Press the "PROG" key to enter the menu, "On / Off" as a select.
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to section 4.15.6
GB
DRO 5
104 Translation of original instructions Version 1.1.8 - 2021-07-29