Inhaltsverzeichnis
Werbung
FRONT BRAKE AND REAR BRAKE
5 - 23
3. Install:
Spring 1
Brake pedal 2
O-ring 3
New
Bolt (brake pedal) 4
19 Nm (1.9 m · kg, 13 ft · lb)
Clip 5
NOTE:
Apply the lithium soap base grease on the
bolt, O-ring and brake pedal bracket.
Install the clip with its stopper portion a fac-
ing inward.
4. Install:
Pin 1
Plain washer 2
Cotter pin 3
NOTE:
After installing, check the brake pedal height.
Refer to "REAR BRAKE ADJUSTMENT" sec-
tion in the CHAPTER 3.
Front brake hose
1. Install:
Brake hose 1
10 Nm (1.0 m · kg, 7.2 ft · lb)
To brake hose holder 2.
NOTE:
Before tightening the bolt (brake hose holder),
pass the brake hose in front of the axle boss
a, then fit it into the hose groove b so that the
brake hose does not contact the nut (wheel
axle).
2. Install:
Hose cover 1
Plain washer 2
Bolt [hose cover (M8)] 3
16 Nm (1.6 m · kg, 11 ft · lb)
Bolt [hose cover (M6)] 4
7 Nm (0.7 m · kg, 5.1 ft · lb)
CHAS
New
Werbung
Inhaltsverzeichnis
