Program A Memory Card In Old/New Format; Add Installation Pin - Jcm-Tech Manager+Dcs Bedienungsanleitung

This allows the programming to be blocked in 126 or 500 receivers via radio
transmission
Access if made by means of Main Menu/Receiver.
Press and on screen the message will appear
Select the type of receiver and press
screen will show:
Press the keys
the option to block the programming by radio. If you press
it will block it and if you press

5.20 Program a memory card in old/new format

Access is made by means of:
Main Menu/Receiver, Main Menu/Mini-Unit or Main Menu/Maxi-Unit.
This allows any memory card to be stored in new or old format. If the MAN-
AGER+DCS detects a new TM, it will store it in new format, and if it detects an old
TM, it will store it in old format.
If the MANAGER+DCS detects that it is a memory card
automatically reconverted with a receiver, it will ask:
This function may also be performed with the keys
Mini-Unit and Maxi-Unit menus.

5.21 Add installation PIN

The installation PIN is a 4-figure number that is entered, through the portable pro-
grammer, in the first transmitter that is saved in the receiver or directly on the
memory card. From this moment, the receiver will recognise this "PIN" in any
transmitter where it is inserted. It will be emitted by pressing the button on the rear
of the corresponding transmitter, and the receiver will automatically program it in its
memory, issuing a long beep
5.21.1 Entering the installation PIN in a TM126 or TM500
Insert the TM in the MANAGER+DCS and select the Main
Menu/Receiver.
Press and the screen will show
Select the type of receiver and press
screen will show:
Select the Receiver Menu/Enter PIN and press
and together. The screen will show
it will release
again. The
and
again. The
.
63
General functions
in the Receiver,