jcm-tech MANAGER+DCS Bedienungsanleitung Seite 175

Using the or
Press . The following message will appear:
The Programmer will then return to the menu:
We recommend making a reservation of codes in the memory card of the
receiver, in order to be able to store transmitters or smartcards without
having to go to the place where the receiver element is installed. For more
information, see the chapter on General functions.
In order to save a copy of the installation in the memory
cartridge, use the
Press . The following message will appear:
Using the or
saved. If another installation is already saved in this sector, the Portable Programmer will
indicate this on the screen by means of the abbreviations Rc if it is a receiver installation,
Mn if it is a Mini-A.C., or Mx if it is a Maxi-A.C.
Press to access the screen that enables the selection
of the installation number where the installation being con-
figured is to be stored. This number can be selected by us-
ing the or
If the number is already occupied, it will be accompanied by the
symbol #. In this case, you must decide whether to overwrite the
previously stored installation or select a different number.
Press . The following message will appear momentarily:
Followed by:
The Programmer will automatically return to the Receiver
Menu/Edit.
Switch off the power supply of the Portable Programmer, remove the memory card
and insert it correctly in the receiver (remembering that this must be switched off).
The installation is completed.
It is very important to note down the installation number and the sector of
the memory cartridge where it has been stored, together with the position
number and the code of each transmitter, in order subsequently to be able
to maintain the installation efficiently.
keys, locate the menu:
or keys to locate the menu:
keys, select the number of the sector where the installation is to be
keys.
41
Creating installations