Creating A New Code; Deleting A Code; Reading "N" Transmitters - Jcm-Tech Manager+Dcs Bedienungsanleitung

MANAGER+DCS 3.0X I

2.3 Creating a new code

Retrieve the installation as indicated in section 2.1 of this chapter.
From the menu:
Press . The installation will appear on the screen:
Press the and
message will appear on the screen:
In the case of a Mini-A.C. or Maxi-A.C., enter the position
from which you wish to create the new code and press
Enter the new code by means of the numerical keys and press
will appear on the screen. The new code will be in the reserve state (R).
Remember to store the installation again in the memory card and in the
memory cartridge in order to make the changes effective.

2.4 Deleting a code

Retrieve the installation as indicated in section 2.1 of this chapter.
From the menu:
Press . The installation will appear on the screen:
Using the or
number will have been deleted.
Remember to store the installation again in the memory card and in the
memory cartridge in order to make the changes effective.

2.5 Reading "n" transmitters

Retrieve the installation as indicated in section 2.1 of this chapter.
From the menu:
Press . The installation will appear on the screen:
Using the or
transmitters.
keys simultaneously. The following
keys, select the code to be deleted and press
keys, enter the position from which you wish to read the
14
. The new code
. The code